Cooling challenging (Landmark V2)
Copyright Claim
Cooling challenging (Landmark V2)
Boost
16
22
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
16
22
11
1
61
21
Released
Description
Will the results printed by using the same printer and the same parameters be the same? Not always
Test your printer's cooling capabilities.
If you have cooling problems when printing, you can try enlarging the scale.
These landmarks are from highest to lowest：
Eiffel Tower(300m)
Empire State Building(381m)
Taipei 101 (508m)
ONE World Trade Center(541m)
CN Tower(553m)
Shanghai Tower(632m)
Tokyo Skytree(634m)
Burj Khalifa(828m)
inspired by minicityart
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
The photos don't seem to be uploading successfully, which should be a problem with mw's system, but thanks for the rating.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very nice. gets a bit flimsy at the top is had to slow my machine down to the lowest speed but very nice model!
The designer has replied
0
Reply
Cooling challenging, isn't it?
Thank you for your rating.
0
Reply
it’s mainly the very thin parts on the very top of the buildings that start wobbling but if you slow down the machine it should print fine. awesome model nonetheless!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
made it for my bedroom to add a bit of pink to it and honestly really like it
The designer has replied
0
Reply
Glad to hear it.Thank you for your rating.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for the rating.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for the rating.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld