This is a neat easter egg candle holder for small 39mm diameter tea pot candles. Make sure you use a heat resistant filament since these candles can get pretty hot on the outside (>60°C).

Tools needed: none

Recommended filament: PETG,GreentechPRO (heat resistant filaments strongly recommended)

Hotend: 0,40mm

Print time:

0,2mm Layer height: 3h 31min

Print instructions:

layer height 0,20mm
2 wall loops
top/bottom shells 5/3 layers
top/bottom shell thickness 0/1mm
sparse infill 5%
sparse infill pattern “gyroid”
Before printing:

Make sure your build plate is clean.

Make sure to leave a review if you liked it.