Fiat punto EVO Phone Holder

Phone Holder Adapter - Fiat Punto EVO (Blue&Me Socket)

This adapter allows you to mount a modern smartphone holder in the original dashboard socket reserved for the old TomTom Blue&Me navigation systems on the Fiat Punto EVO (and similar models like the Punto 2012).

It is designed to fit perfectly into the proprietary dashboard port, ensuring a solid and vibration-free grip without needing suction cups on the windshield or clips on the air vents.

🇬🇧 Features

• Direct Fit: Slots directly into the dashboard's "Blue&Me" port (top center).
• Ball Joint Compatibility: Designed to work with standard 17mm ball joint phone holders (very common standard).
• Sturdy Design: Engineered to handle road vibrations and keep the phone stable.
• Clean Look: Maintains the dashboard's aesthetics without wires hanging across the steering wheel.

🇮🇹 Caratteristiche

• Montaggio Diretto: Si inserisce direttamente nella predisposizione "Blue&Me" originale sul cruscotto (al centro sopra le bocchette).
• Compatibilità a Sfera: Progettato per supporti telefono con attacco a sfera standard da 17mm.
• Grande Tenuta: Disegnato per resistere alle vibrazioni della strada e mantenere il telefono stabile.
• Design Pulito: Mantiene l'estetica del cruscotto senza ventose sul vetro o clip che bloccano l'aria condizionata.
  
  📱 Hardware Compatibility / Compatibilità Hardware
• This model acts as a base adapter. You will need a commercial phone gripper/magnet to attach to the ball joint.
• Tested with / Testato con:
• Lamicall MagSafe Car Mount (Model referenced in photos)
• Amazon Link: https://www.amazon.it/-/en/dp/B0C4NGG4QG

• Note: Any phone holder with a standard tightening nut and socket for a 17mm ball should work.

  ⚙️ Printing Settings / Impostazioni di Stampa

• Material: PETG, ASA, or ABS recommended (PLA may warp in a hot car during summer).
  • Consiglio PETG, ASA o ABS per evitare che si deformi col calore estivo.
• Infill: 15% - 30% (Gyroid or Grid) for strength.
• Walls/Perimeters: 3 or 4 walls for the ball joint stem to ensure it doesn't snap under tension.

• Supports: [Insert your specific recommendation, usually "Tree supports needed for the locking tabs" or "No supports needed if printed upside down"].

  🔧 Installation / Installazione

• Push the adapter into the dashboard socket until it clicks/seats firmly.
• Unscrew the nut from your commercial phone holder.
• Place the nut over the 3D printed ball.
• Snap the phone holder onto the ball.
• Tighten the nut.