Holder for miniatures - Paint smart - Miniaturenhalter
Copyright Claim
Holder for miniatures - Paint smart - Miniaturenhalter
Boost
39
90
12
Print Profile(6)
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
Designer
2.5 h
4 plates
Guide - 0.16mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Handle - 0.16mm layer, 2 walls, 15% infill
Designer
56 min
1 plate
Slider - 0.16mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Click to see more
Open in Bambu Studio
Boost
39
90
12
7
116
119
Released
Description
This miniature holder is used for painting small figures without having to constantly put them down or touch the figure.
The Schieber.3mf file is needed twice!
The slider has hooks on two sides, each of which is connected to the opposite slider with a rubber band. This will clamp the miniature in place.
Have fun with it!
Comment & Rating (12)
All
Great design! Like a few other comments the assembly wasn’t spelled out so it took me a minute the guide rail supporting the two clamping halves is printed with support material in the center hold. Remove the support push flange through and CA glue the rotating flange to the handle. I only put glue in the bottom of the handle and taped off the handle to guide rail surface and everything works as expected.
Note: I know I don’t have the rubber band installed correctly.
1
Reply
Print Profile
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
Nice model.
0
Reply
Print Profile
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
Very nice! Looks a lot nicer than even most of the commercial for sale ones I've seen!
0
Reply
Boosted
Print Profile
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
It just miss some infos on how to build it and securize rotation (i used glue)
1
Reply
As uzuniita said, anything to help with assembly? specifically how do I attach the handle to the clamping mechanism?
It looks like there's a spot for a large tapered screw but no threads in the bottom. Or perhaps there's supposed to be a plug that could be glued in, but there's no plug defined.
1
Reply
ho! i printed It but i this its usefull to Say how to assemble It.
1
Reply
Print Profile
A1 mini, 0.16mm layer, 2 walls, 15% infill
Lack of instructions was confusing at first but it's a lovely little tool and *much* cheaper than buying a similar one from a store.
0
Reply
Print Profile
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
Printed well look forward to giving to my friend to paint our DnD mini's
0
Reply
Print Profile
A1 mini, 0.16mm layer, 2 walls, 15% infill
Printed well.
0
Reply
Print Profile
4 Plates, All parts - 0.16mm layer, 2 walls, 15% infill
Very nice model, so similar to what is possible to buy in a store.
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld