Cute elephant hueforge by Bunk.Wire

Bunk.Wire

Generative 3D Model>Hueforge & Lithophane

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.08mm layer, 1 walls, 100% infill

Designer

1.6 h

1 plate

4.8(13)

0.08mm layer, 1 walls, 100% infill

4.7 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

116

186

Released

Description

Cute, sleeping elephant

*created with filament painting technique using hueforge software.

Remember if you want to scale, do it only with x and y axis, z must be the same as original.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Basic Blue Gray
PLA BambuLab Basic Beige
PLA BambuLab Basic Jade White

Swap Instructions: if you don't have ams just put pause on specified layers and swap filamen manually
Start with Black
At layer #10 (0.88mm) swap to Blue Gray
At layer #15 (1.28mm) swap to Beige
At layer #21 (1.76mm) swap to Jade White for the rest.

Comment & Rating (15)

@user_2907676246

Print Profile

0.08mm layer, 1 walls, 100% infill

It’s cute, and I really like it, but the direct print slicing is slightly off. I did end up using pink rather than beige, but that shouldn’t have impacted the way the clouds and the bottom of the moon and elephant feet printed. Again, still cute, just not as detailed as the photo might have you think. *I included a photo of the raised portions that ended up being black rather than a different color*