Glider kit card (flies great)
Copyright Claim
Glider kit card (flies great)
Boost
396
754
122
Print Profile(5)
0.05mm layer, 1 walls, 5% infill
Designer
1.1 h
1 plate
0.05mm layer, 2 walls, 5% infill
1.1 h
1 plate
PLA 0.16mm layer, 3 walls, 13% infill
27 min
1 plate
0.08mm layer, 2 walls, 5% infill
49 min
1 plate
Click to see more
Open in Bambu Studio
Boost
396
754
122
7
1.7 k
1 k
Released
Description
This is a kit card of a glider. It glides very well if weighted properly. I made this because I saw many kit card airplanes that did not fly and wanted to make one. It must be printed with a 0.05 mm layer height. If the glider nose dives then print out the light weight securer. If the airplane flips backward print out the heavy weight securer. (also make sure that the wings are slanted back to provide lift. If they are slanted forward then the fuselage sides need to swap)
Some recommendations for this print are.
- Clean your print bed before printing.
- Print with around 5% infill.
- Do not print to fast. (stay near 200 m/s or less)
Documentation (5)
Assembly Guide (5)
Comment & Rating (122)
All
Print Profile
0.05mm layer, 2 walls, 5% infill
It is the most delicate thing I’ve printed but it came out great and works. You are pushing the limits on what can be printed!
The designer has replied
4
Reply
Boosted
credits to the creator! i love it <3
0
Reply
Be sure not to spray glue, otherwise you won't be able to take it off at all，一定不要喷胶，要不然根本拿不下来！！！！！
2
Reply
Print Profile
0.08mm layer, 2 walls, 5% infill
nice model
1
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 5% infill
Just awesome print
0
Reply
Print Profile
0.08mm layer, 2 walls, 5% infill
Great design. Flies not that good, but it is a lot of fun to try. Great simple print. Printed really fast too!
0
Reply
Print Profile
PLA 0.16mm layer, 3 walls, 13% infill
Print great and it flies well. Great job!
0
Reply
Print Profile
0.08mm layer, 2 walls, 5% infill
it was a little hard to put together but it flies well and work well once put together.
0
Reply
Print Profile
0.05mm layer, 2 walls, 5% infill
it's amazing that this can be printed and actually fly
(Edited)
0
Reply
Print Profile
0.05mm layer, 2 walls, 5% infill
Good profile, the only problem I had was with the balance weight. There was a little layer shift.
(Edited)
0
Reply
Print Profile
0.05mm layer, 2 walls, 5% infill
Worked great. Kinda'of flies a bit
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld