Nerf Barrel
Copyright Claim
Nerf Barrel
Boost
2
7
2
Print Profile(1)
0.2mm layer, 6 walls, 25% infill, Brim
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
2
7
2
0
11
5
Released
Description
Nerf barrel for my son's nerf commander elite 2, a little tight to get on but I think its just right, no supports needed!
Comment & Rating (2)
All
Print Profile
0.2mm layer, 6 walls, 25% infill, Brim
(Edited)
Bed Adhesion Issue:Nice object but I had to do another profile with a brim. The adhesion surface was not sufficient to allow the print to finish properly. I tried 2 times after washing the PEI plate without success. With the brim it goes well on first attempt
The designer has replied
0
Reply
Sorry to hear about the issue, but glad it worked out in the end! I printed it without a brim, but ill edit the profile just to be safe for future printers!
(Edited)1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld