Print Profile(1)
0.2mm layer, 3 walls, 15% infill
10 min
1 plate
Open in Bambu Studio
Boost
1
0
1
0
2
2
Released
Description
Print at 100% infill.
Needs two 6x2mm neodym magnet.
Use superglue for the magnet. Make sure the magnet is flush with the top while the glue hardens. Let the glue fully dry before you put it on your whiteboard.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Sehr schöner Entwurf, persönlich finde ich das Loch zu tief.
Nur noch einkleben und fertig.
Danke
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld