Print-in-Place Guitar Pick Holder Box
Copyright Claim
Print-in-Place Guitar Pick Holder Box
Boost
48
87
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
48
87
16
5
172
185
Released
Description
Folding container for maximum 30 thin/medium/heavy picks. I used ordinary fender picks, the box lid closes perfectly on the top of each pick so they don't fall out of their slots.
Print instructions
Print it in place with no supports or assembly needed. The model shown was printed in Glow in the Dark PLA with 10% infill and .2mm layer height - any higher than that might make the hinge excessively clicky or not move at all.
Once removed, gently bend the hinge until it clicks and should rotate freely.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This turned out so food I love it.
0
Reply
sure must taste good
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect for my picks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice print.
0
Reply
The model is very nice and useful, but the top cover and the connection part are very thin and may crack.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
printed in wood PLA, came out fantastic.
stained it red mahogany
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld