geared wheels with magnets children's toy
Copyright Claim
geared wheels with magnets children's toy
Boost
4
7
1
GIF
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
4
7
1
0
9
3
Released
Description
a simple toy system of gears, for example on a refrigerator.
contains :
-gear set
-center pin
-retaining ring
printed:
-without supports
-2 perimeters
-5% infill
print the number of pins and rings according to the number of wheels printed
I used a neodymium magnet 1.5 mm thick and 10 mm wide to attach it to the fridge
for exampleplace the printed wheel on the center pin and secure with a ring
have fun with little baby printers
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 5% infill
The cogs were a bit heavy, especially for the smaller magnets that I have, so I need to add more. Also, I had problems with too much friction with some of the centre pins, but this could be a printer calibration issue rather than an issue with tolerances. Either way, my kid loves them!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld