A first attempt at a modular-ish headset stand to put over my laptop and store random things like card readers and powerbanks on, and also hold my two headsets.

The larger one sits in two of the smaller trays and leans on the middle column, the smaller one (a Jabra Evolve 2 65) is held by the hot dog shaped holders and raised a little with the hex nut spacers.

The base grid just fits into a bambu lab P1S, so a printer with a nominal 256x256 base is needed. I printed that with solid wall settings.

If you want to make your own additions, the hexes have a radius of 5mm (center to edge) and the grid is 2.5mm thick, I modelled with a tolerance of 0.1mm and it's a tight fit.

If your laptop or whatever you put it over is wider than 21cm you'll need to use the wide legs as shown in my pictures.