Anet A8 Improved Bowden Titan Extruder with Spool Filment Holder
Anet A8 Improved Bowden Titan Extruder with Spool Filment Holder
Print Profile(0)
Description
Summary
The extruder mount was to thick to mount my Titan so its little smaller with a small brace. Never used tinkercad so it is what it is lol. (This is made to mount on the RIGHT side,Mirror if you would like it on the left side like in the pictures.)
Made to use all stock screws that come with the titan.
i have a titan clone and had to sand down the cover where the shaft sits due to being clone quality. i was having a problem when i would tighten the cover it would be hard to spin.
Will have to drill one hole due to only having 3.
May edit latter so the titan can turn a little bit if you have a loose gear mesh.
11/22/18
Added a block and pin if you would like to move the spool over a little. may need to scale up at least 2%-3% if your printer is little off.
Print Settings
Printer:
GeeeTech A10M
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
40%-50% w/Block,30% without block
Filament: Some china brand PLA Green
