Print with a brim.

*added a wing to the model to help with turning*

*added a zip tie slot *

*works with the s1 pro but can’t be screw down. this was verified by another user*

This should fix the issue with the heated bed wires from flexing over and rubbing on the motor.

Installation notes.

• 1-remove the screw right under the bed wire that s fastening the bottom cover.
• 2-pull the bed all the way to the front.
• 3-install the support bracket.

please leave ⭐ review and rate.

Check out my other designs.

https://cults3d.com/en/users/3DeezNutZ/3d-models

https://www.printables.com/@3DeezNutz_752861/models