In case anyone else assumes that this print is for a plate holder with a base/wing that slides under one side of your printer to keep it from falling over, it is not. I have no clue what the flat wing off the side is or does, but it is not attached and is a completely seperate piece that offers zero value as far as I can tell. I’m severely visually impaired so I may be missing something, but I can’t figure it out. Seems great otherwise. It holds five plates just fine. I have freakin evil cats and with my vision it’s easy for me to bump things so I need one that can’t just be accidentally knocked over. I’ll probably just use double sided tape to hold it as to not waste a print. Not knocking the print, it’s fine, just an fyi.