Search models, users, collections, and posts
Bag Clip
IP Report
Print Profile(3)
125% - 0.2mm layer, 2 walls, 15% infill
56 min
2 plates
0.2mm layer, 2 walls, 15% infill, PLA and PETG on A1 Mini
1.4 h
2 plates
0.2mm layer, 2 walls, 15% infill
41 min
2 plates
Open in Bambu Studio
Boost
46
96
28
16
202
124
Released
Description
I wanted a bag clip that needs only printed parts and that has a wide surface to properly seal the bag.
There is not a lot of options that meet this criteria, so i decided to design it myself. I hope that it can be useful for everyone else too.
I suggest to use PETG for the spring and PLA for the other part. But personally I used PLA for everything and it works perfectly
Print without support and i suggest 100% infill even if on the flat part of the clip is not necessary
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (28)