Anti Vibration Feet for X1 and P1 Series Printers by ebjspecials

ebjspecials

3D Printer>3D Printer Accessories

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

0.2mm, 3 walls, 20% infill, v3.1 25mm

Designer

4.6 h

1 plate

0.2mm, 3 walls, 15% infill, v3.1 25mm

Designer

4.1 h

1 plate

0.2mm, 3 walls, 20% infill, v3.1 20mm

Designer

3.7 h

1 plate

5.0(2)

0.2mm, 3 walls, 20% infill, v3.1, 15mm

Designer

3 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Hello Makerworld Community,

Here comes my model of an "anti-vibration foot" for the Bambu Lab P1S, P1P, X1 and X1C.
The outer edge of the base looks slightly over the edge of the housing so that the housing can rest on it and noise is reduced.
The original feet “do not” have to be removed for this.

The whole thing was printed by me, with TPU filament at a max volume speed of 4qmm/s.

If you have problems with this, use your own TPU printing profile.

There are now 2 models with a height of 15mm and 20mm.

Please use the current version: v3.1
Latest changes: Infill and speed optimized

Hallo Makerworld Community,

hier kommt mein Modell eines "Anti Vibrationsfußes" für den Bambu Lab P1S, P1P, X1 und X1C.
Der Aussenrand des Fußes schaut etwas über den Rand des Gehäuses, damit das Gehäuse hier auch noch aufliegen kann und Geräusche reduziert werden.
Die original Füße müssen "nicht" entfernt werden dafür.

Gedruckt wurde das ganze von mir, mit TPU Filament bei einem max Volume-Speed von 4qmm/s.
Solltet ihr Probleme damit haben benutzt euer eigenes TPU Druckprofil.

Es gibt nun 2 Modelle mit einmal 15mm und 20mm Höhe.

Bitte nutzt den aktuellen Versionsstand: v3.1
Letzte Änderungen: Infill und Geschwindigkeit optimiert

Comment & Rating (7)

@infamous61

I like the straightforward, simple design. I liked being able to leave the original feet in place on my Bambu P1S. I added another 5mm to the height and went with an Archimedean Chords 20% infill, generic TPU. I do believe there is a noticeabledifference in my table not shaking.

The designer has replied

@ebjspecials

I hope you only added the 5 mm at the bottom and didn't scale the height, otherwise the original feet will no longer stand on the intended support so that they are spring-loaded.

@infamous61

Replying to @ebjspecials :

Yes, I did add to the bottom. You have no idea how happy I am with how my P1S is printing now. Thanks

@ebjspecials

Replying to @infamous61 :

TY for your positiv Feedback.