3D Models
Contests
Forum
Maker's Supply
MakerLab
Log In
ESP32 Cam housing
laisch
Follow
Hobby & DIY
>
Electronics
Copyright Claim
ESP32 Cam housing
laisch
Follow
Boost
21
42
8
3D Preview
Print Profile
(1)
All
X1 Carbon
P1S
P1P
X1
X1E
A1
0.2mm layer, 6 walls, 25% infill
Designer
44 min
1 plate
4.3
(7)
Open in Bambu Studio
Boost
21
42
8
0
104
65
Released
Description
Housing for ESP32 Cam modul (Tinker board)
esp32
esp32cam
thingiverse
esp32cambox
esp32tinker
Comment & Rating (8)
Please fill in your opinion
Add Photo
(0/5000)
Post
All
Top
Most Likes
Newest First
Most Replies
@LDVCO.
Print Profile
0.2mm layer, 6 walls, 25% infill
Print quality was fine
0
Reply
@davi
Print Profile
0.2mm layer, 6 walls, 25% infill
Prints well with Bambu PLA but final assembly fits a bit loosely
0
Reply
@lbennett49
Print Profile
0.2mm layer, 6 walls, 25% infill
very well done best ESP 32 cam enclosure I found yet thanks for the hard work
The designer has replied
1
Reply
@laisch
Thx ;)
0
Reply
@svierq
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
@jenskoschnick
Print Profile
0.2mm layer, 6 walls, 25% infill
Other Issues:
mit sdcard leider sehr schlecht einzusetzen und usb- Kabel und Antenne muss noch überarbeitet werden.
0
Reply
@gregor.aust
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
@bri0nac
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
Related Models
ESPS32 Cam Case
Dave R
0
2
1
ESP32-Cam Case (Bambu Edition)
CasperJohansen
0
12
22
ESP32-Cam Case Type-C MB ver.
Thexu
0
4
1
Phone / Camera - Tripod
MakerVerse Designs
1
37
70