It is strongly recommended to review the introduction before selecting print. The English translation provided by GPT is shown below.

Case for ESP32-Cam With Type-c MB

适用于组合Type-C母座的ESP32-Cam的外壳

请确保你的底座看起来像是这样的，使用Type-C接口，并且是稍微内凹的

我已经制作了几个迭代版本，现在版本是看起来最好的，包括了多个重要的开槽，并且尺寸非常合适

该模型不需要支撑即可打印，但由于内凹的Type-C接口，开槽部位打印效果可能较差

侧边的天线位置预留了一个小开口，你可以使用宽度小于16mm的fpc天线贴在底壳外缘，效果应该不错！

请注意，安装上壳时，可能会遇到难以卡紧的情况，这是因为摄像头开孔部分可能在打印时出现了略微公差，使用小刀在摄像头位置削去薄薄的一层即可改善这种情况

！！请注意，在拆上壳时，有可能会因为摄像头部位卡的太紧导致整个摄像头被带下，这可能对你的设备造成伤害，强烈建议固定摄像头后再取下外壳（例如用手指轻压镜头外壳）！！

默认版本的上壳包括了排母部分的开孔，你可以很方便的使用杜邦线进行连接其他元件或电池，如果你不需要这个开孔，可以选择另一个版本

English Ver.

Ensure your base looks like this (pic. 1), uses a Type-C interface, and is slightly recessed.

I've created several iterations, and the current version is the best-looking one, incorporating several important slots and fitting perfectly.

This model can be printed without supports, but the slot area may have poor print quality due to the recessed Type-C interface.

A small opening is reserved on the side for the antenna. You can attach an FPC antenna with a width less than 16mm to the outer edge of the base, which should work well.

Please note that difficulty may be encountered when fitting the top cover due to slight tolerances in the camera opening during printing. Use a small knife to shave off a thin layer around the camera to improve the fit.

!! Caution: When removing the top cover, the camera may be pulled out due to being tightly secured. This could damage your device. It is strongly recommended to secure the camera before removing the cover (e.g., by lightly pressing the lens housing).！！

The default top cover includes an opening for the fan, allowing you to easily connect other components or batteries using DuPont wires. If you don't need this opening, you can choose an alternate version.