ESP32 Cam housing
Copyright Claim
ESP32 Cam housing
Boost
17
34
8
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
44 min
1 plate
Boost
17
34
8
0
88
59
Released
Description
Housing for ESP32 Cam modul (Tinker board)
Comment & Rating (8)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Print quality was fine
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Prints well with Bambu PLA but final assembly fits a bit loosely
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
very well done best ESP 32 cam enclosure I found yet thanks for the hard work
The designer has replied
1
Reply
Thx ;)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Other Issues:mit sdcard leider sehr schlecht einzusetzen und usb- Kabel und Antenne muss noch überarbeitet werden.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld