Screw-less wire organising brackets / clips for (Misumi 2020) extrusions with minimal printing and installation time.

Use these as to make easy, clean and serviceable wiring.

Can be used as alternative wiring organisation solution if you do not want to go with complexity of cable channels (and as we all know printed channels just sucks…)

Can be used for Misumi 2040 or 4040 extrusions as well, as they say - if it works, it works.

Bracket anchor is based on famous Voron Trident cable frame anchors.

Recommended print settings:

• Layer height: 0.2mm.
• Extrusion width: 0.4mm, forced.
• Infill pecentage: 42-62%
• Infill type: grid, gyroid, honeycomb, triangle, or cubic.
• Walls: 1 for top/bottom layers, 4 for all other.
• Solid top/bottom layers: 3.
• Supports: None.