Palworld bowl 帕鲁碗
Remixed by
Copyright Claim
Palworld bowl 帕鲁碗
Remixed by
Boost
6
3
3
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.9 h
2 plates
Boost
6
3
3
0
18
3
Released
Comment & Rating (3)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Beautiful in design, however it was very, very difficult to print out the ornate decorative pieces. Had to print those out multiple times just because of how delicate they were. Tried using just the filament and also fine tuning in the Bambú desktop app to use support PLA (with somewhat better results.)
The designer has replied
0
Reply
Yes, The original model is single model that need AMS to print. I separated it as multi parts, the pattern parts is too thin, it is a bit difficult to print indeed.
0
Reply
还得是你
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld