This bowl's woven appearance was designed to replicate the look of a basket.

This is part of my Woven Series.

Print Settings

• Use the classic perimeter generator - drooping will occur with Arachne
• 0.2mm layer height
• Change infills based on height
  • 25% for base and bottom rope section - helps support top layers of the base
  • 0% for main section - saves print time
  • 25% for top rope section - helps with top layers
• 0.1mm layer height may be used for the top few layers to improve the finish of the top rope section

Buy Me A Coffee

The following filaments were used in the picture above:

• Bambu Lab Matte Dark Brown PLA