Tesla Model 3 Cupholder Insert, designed to be printed face down on a textured PEI plate. Two profiles are available, one in PLA and one in ABS. PLA is not recommended for high-temperature environments and may warp in extreme heat. NOTE: I do not own the rights to the logo in this model, and it is designed as fan art. This is not intended for commercial use.
Assembly does not require glue, the center piece should slide into place with minimal force and stay in place when printed as-is. If it is too tight to fit center piece into insert, adjust X and Y scale to 99.9% of size for small center piece and leave Z scale at 100%.