Lithophane Christmas bell LED 9V battery holder.

Link to Lithophane Christmas bell => https://makerworld.com/en/models/204482#profileId-224666

Material: Led strips 12V 5cm (I used cold white 5630 120LED) Aliexpress, TME

9V battery - I recommend this rechargeable 9V battery Aliexpress, TME

9V battery holder - Aliexpress, TME

Switch - Aliexpress, TME

Wire 0,12mm2 red ane black - TME(RED) - TME(BLACK)

Heat shrink black tubing 1.6mm or 2mm - TME, Aliexpress

Tools: Soldering iron
Splitting pliers
Knife
Lighter
Screw M4 or M5, I recommend a piece of approx. 30 mm.

Adhesive “Pattex plastic”
Zip ties 1x

Instructions:

1.Preparation

2.Punch a hole with a 1.5 mm Allen key.

3. Strip the wires and tin them. And pass through the holes of the holder.

4. Shorten the wires on the battery holder to approx. 6 cm. Strip the wires, tin them and put on a piece of heat shrink tubing.

5. Solder the wires from the battery holder and the holder. And heat the tube with a lighter.

6. Tin the contacts on the switch.

7. Place the heat-shrink tubing on the wires that we passed through the hole for the switch. We solder the wires to the contacts and heat the tubes with a lighter.

8. Place the switch in the hole. Heat the screw (M4/M5) with a lighter and press the studs. So that the switch stays in the hole.

9. Shorten the black wire to approx. 3.5 cm. Strip the wire and solder it to "-" on the led strip.

10. Glue the LED strip to the holder. Cut the red wire, strip it and solder it to the LED strip.

11. TEST Connect the battery and test the function of the switch.

12. I recommend sticking the LED strip with glue.

13. Finally, after the glue has dried, pinch the zipper and put on the shade for better light dispersion.