Ive designed this to help with re-spooling filament onto bambu re-usable spools. It has a small filament holding hole which holds the filament snug while the initial layer is pulled onto the the bambu spool, this has worked wonders for me so I thought id share it to help others.
Tested to fit the All bambu spools.
Recommended material; ABS
Build Plate; Bambu High Temp Plate, The rough base finish using PEI Plate is ok but not Ideal.
Changes on Bambu Studio;
0.2mm standard layer height,
2 wall loops,
Sparse infill density 25%,
Sparse infill pattern Gyroid,
Supports OFF,
Brim OFF.