AGV K1S Action cam chin mount V2
Copyright Claim
AGV K1S Action cam chin mount V2
Boost
9
8
9
Print Profile(1)
0.16mm layer, 4 walls, 25% infill
Designer
29 min
1 plate
Boost
9
8
9
1
66
15
Released
Description
V2 of my action camera chin mount for the AGV K1S.
I greatly reduced size as well as improved the camera angle.
In addition the new version does not require supports.
You will need a “j-hook” like this or something similar, as well as adhesive to stick it to the helmet.
I have ordered this set from Amazon since it contains everything that I needed.
I recommend ASA or PETG.
I made the mount/baseplate by 3D scanning the front of the helmet and then simply designed the baseplate in fusion 360 and cut it with the surface from the scan.
Comment & Rating (9)
All
just printed one. it’s half the size compared to my last mount; also slimmed a bit on the sides. wondering how It’ll hold up… have you had time to test it out? very nice and detailed though like the ones you can buy maybe even better.
(Edited)
The designer has replied
0
Reply
Hello!
Yes I have been using mine for ~2000km now driving speeds up to 180km/h and it holds up perfectly fine with M3 all weather adhesive.
0
Reply
Boosted
cool
1
Reply
what would be the downside of printing in pla
The designer has replied
0
Reply
Hi.
PLA isn’t very heat resistant so I would be concerned about it deforming on a hot summer day.
For example when you leave the helmet outside on your bike etc.
Also PLA is not as UV resistant as ASA & PETG
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
1
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
1
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 4 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld