Overhang Support Tests - Bridge Flow Calibration
Copyright Claim
Overhang Support Tests - Bridge Flow Calibration
Boost
6
8
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
6
8
3
0
76
45
Released
Description
With this test print you can fine tune you overhang and supports. The most crucial factor with this test print is the Bridge Flow Rate.
After that comes the distance between the support and overhang. Altnernate the Bridge Flow Rate higher and lower the given value until the overhangs look good. Then start to fine tune you supportdistance to the point where the support is easy to take off.
Fine tune you overhangs!
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Todo perfecto!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice little test tool.
Used it to test PLA Support Filament and PVA.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld