SIMPLE TESTER FOR BRIDGES AND OVERHANGS by claudiogirolami

claudiogirolami

3D Printer>Test Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer standard PLA - MODIFY AT WILL

Designer

21 min

1 plate

5.0(2)

Boost

Released

Description

This object is very useful for testing bridging and overhanging of your printer and therefore being able to calibrate it to obtain better results.
In fact, this object is made up of two semi-arches (formed by segments angled at 20,40,60 and 80 degrees), one of which without any support (overhanging) and the other inserted between two thin walls (bridging).

Happy printing!

What about offering me a coffee ?
https://buymeacoffee.com/menkheperra

Don't hesitate to subscribe to my patreon ...
https://www.patreon.com/claudiogirolami

Comment & Rating (5)

@user_148914258

Print Profile

0.2mm layer standard PLA - MODIFY AT WILL

Good for testing the printer,based on the results from the previous person I think some work needs to be done on my printer

The designer has replied

@claudiogirolami

Yes, I bet your printer isn't calibrated at least for the filament you used... Don't hesitate to perform a manual calibration (or automatic if you own an x printer) and once calibrated post again a picture to compare the results. Thank you pal !!

@user_148914258

Replying to @claudiogirolami :

I had printed that on the X1C bought a week ago, I tried cleaning the carbon rods and tightening the belts and tried to print it again but no difference. Also just printed it on a brand new A1 mini it still looks pretty much the same,may be a tiny bit better.