I put a lot of effort into this filament painting. I hope you like it :)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Overture Black PLA PolyTerra Charcoal Black PLA Overture Cement Gray PLA+ Sunlu Gray PLA BambuLab Basic Gray PLA Overture Light Gray PLA+ Esun Bone White PLA Ziro Snow White Swap Instructions:
Start with Black At layer #7 (0.64mm) swap to Charcoal Black At layer #10 (0.88mm) swap to Cement Gray At layer #15 (1.28mm) swap to Sunlu Gray At layer #17 (1.44mm) swap to BambuLab Gray At layer #21 (1.76mm) swap to Light Gray At layer #27 (2.24mm) swap to Bone White At layer #30 (2.48mm) swap to Snow White for the rest.
Enjoy my work? Support me by joining my club on printables . Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.