Wemos D1 mini + LED Strip Case
Copyright Claim
Wemos D1 mini + LED Strip Case
Boost
31
53
25
GIF
GIF
GIF
GIF
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
20 min
1 plate
0.2mm layer, 2 walls, 15% infill
18 min
1 plate
0.2mm layer, 2 walls, 15% infill
22 min
1 plate
Open in Bambu Studio
Boost
31
53
25
3
159
144
Released
Description
No supports needed. Printed in PLA with a 0.16 mm layer hight.
The connector itself is stuck to the board using some nano tape, but some hot glue would do the job too.
Comment & Rating (25)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
bisschen zu wenig toleranzen
The designer has replied
0
Reply
it don’t seem to be a model problem, but a printer/filament tuning problem
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fit together perfectly
0
Reply
Fits perfectly, thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A very nice design that snapped right together. Thanks for sharing!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints nice. Fits good! Thank you!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works well
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Great little case. Thanks.
0
Reply
Thank you for the casing, great work.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great file and profile!
0
Reply
Nice file, had to slightly modify for my D1, but the fit is nice!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld