This ghostbuster painting of Vigo the Carpathian was made using HueForge. It requires 6 colors Black, Dark Gray, Brown, Orange, Yellow, and White. I used all Matte colors for this print because the colors seem to blend well together. Matte also helps reduce stringing on the print, but you can use normal PLA if that is all you have. Please keep in mind depending on the brand and shade of your PLA your results may vary.
Print at 100% infill with a layer height of 0.08, the first layer needs to be 0.16, and a wall loop of 1.
I did not use a prime tower, it is not needed. This print should take about 2h47m if you use the 3mf settings.
Swap Instruction are as followed:
Start with Black
At layer #7 (0.64mm) swap to Dark Gray
At layer #10 (0.88mm) swap to Brown
At layer #13 (1.12mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow
At layer #19 (1.60mm) swap to white
Happy Printing!