Screen Bezel for P1S & P1P (Proboby better fit)

Remixed by

Screen Bezel for P1S & P1P (Proboby better fit)

Remixed by
Boost
5
17
6

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

PETG 0.16mm layer, 2 walls
PETG 0.16mm layer, 2 walls
Designer
26 min
1 plate
4.8(4)

Boost
5
17
6
0
29
24
Released

Description

I tried several screen bezels from MakerWorld, but the common problem was that they were too tight, making it very difficult to install or almost impossible to remove. I found that the original screen's cross-section was actually a trapezoid, so I made some modifications. After printing and testing, the result was satisfactory.

 

我尝试了网站里好几款屏幕边框,普遍的问题是太紧了,非常难安装到位,或是安装好后几乎拿不下来。于是我仔细观察,发现原厂屏幕的横截面实际上是一个梯形,于是我做出了相应的修改,经过打印测试,工作良好。

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Print Profile
PETG 0.16mm layer, 2 walls
Works as intended. No Flaws, great print.
0
Reply
Print Profile
PETG 0.16mm layer, 2 walls
The finish is nice but it’s not a tight fit.
The designer has replied
0
Reply
Thank you to point out this, sorry for the inconvenience. I used Kexcelled PETG for this is a tight fit. Maybe due to different material, you may scale down a little bit (like say 99.5%)
0
Reply
太大了,放上去松松垮垮的,影响按键操作,pla我缩到99.56刚好卡紧不会动
0
Reply
Print Profile
PETG 0.16mm layer, 2 walls
Had to print at 99.5% as 100% was not snug with Inland PLA+.
0
Reply
Print Profile
PETG 0.16mm layer, 2 walls
0
Reply
No more