Chameleon Pen Holder
Remixed by
Chameleon Pen Holder
Remixed by
Boost
53
49
14
Print Profile(1)
0.12mm layer, 2 walls, 10% infill
2.7 h
1 plate
Open in Bambu Studio
Boost
53
49
14
2
88
75
Released
Description
I printed PRIma's pen holder and found that for heavier pens it just fell over. I added a leaf Stabilizer so that this does not happen. I think it turned out very well.
Note: This is not technically a remix of the smoothed version of PRIma's, but a remix of BS3's as I could not get PRIma's to load properly in my editor. But since it is directly inspired by PRIma's I am considering it a remix of theirs.
Dimensions: 86.95mms tall, 49.6mm wide, 84.3mms long
Comment & Rating (14)
All
Very nice
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
X1Carbon - Printed in generic PLA silk fine without tree supports. I did receive and error about floating parts when I went to slice in bambu, but had no issues. I printed in Sport mode after the first few layers. I have included a photo with my fingernail showing the depth the pen reaches. I have also included a photo of 3 pens. The black and white pen does not fit in the hole. Its super cute and I will likely print more for family and friends <3 Thank YOU A+
0
Reply
Its cute🖊️🦎🌿
Made with Elegoo red green silk and A1 Mini.
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 10% infill
Very Cool! Wife loves it!! Thanks for the Design!
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
super cute and tiny
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
Easy print, support comes off easy
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld