SUNLU SPOOL ADAPTER FOR AMS LITE
Copyright Claim
SUNLU SPOOL ADAPTER FOR AMS LITE
Boost
12
20
3
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
1.1 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
12
20
3
0
33
18
Released
Description
I recieved some new PLA+ filament from SUNLU, and the spool were made out of cardboard. The diameter of the spool would not fit the AMS Lite nor the adapter i had in stock for the SUNLU plastic spool, so i made a new one :
It's in two parts, they are the same, and they are design to fit snuggly on each side of the spool, then it will fit the AMS Lite.
It prints in 1 hour and use only 30 grams of filament.
Printed in PLA+ from SUNLU, but PLA should be enough.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
didn't work for my sunlu fillament
The designer has replied
0
Reply
sorry about that, can you tell me what did not work so i can improve the design ?
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld