This is to help heat up your chamber for when you print high temp filaments
Your printer will need to be rooted to make this work.
Fans will show 100% when they are off
Printer.cfg
[temperature_fan bed_fans]
pin: !PA0
cycle_time: 0.0100
hardware_pwm: false
max_power: 1
shutdown_speed: 0
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PC5
min_temp: 0
max_temp: 110
control: pid
pid_Kp: 4.0
pid_Ki: 1
pid_Kd: 0.2
pid_deriv_time: 2.0
target_temp: 10.0
max_speed: 1.0
min_speed: 0.0
[output_pin bed_fans]
pin: !PA0
pwm: True
cycle_time: 0.0100
hardware_pwm: false
value: 0.00
scale: 255
shutdown_value: 0.0
Orca Slicer
Printer Settings
Machine start G-code
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=mcu_fan TARGET=50
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=bed_fans TARGET=10
Filament setting:
end print
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=bed_fans TARGET=10
start print
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=chamber_fan TARGET=60
SET_TEMPERATURE_FAN_TARGET TEMPERATURE_FAN=bed_fans TARGET=60