This is a remix of the M32 case, paddle clip, and 18650 cell holder.
Credit to W7OSU club members: Luke Lodwig, KJ7FQB, and Jason Wang, N0BOY
Modification
- Extended the case to enclose the battery holder
- Added wiring slots on the bottom of the case
- Revised the paddle clip for a better fit (1.5x width)
- Added relief on the battery holder to fit the SMA connector
Parts from Morserino kit
- 1 x top acrylic plate
- 6 x 6mm M3 screws (4 for top, 2 for bottom)
- 4 x 15mm nylon stand-off spacers (for top)
- 2 x 6mm nylon stand-off spacers (for bottom)
Parts to buy
Notes: Use springs on both the positive and negative contacts. Double-check polarity when installing the battery!!!
Pre-assembled
![](https://makerworld.bblmw.com/makerworld/user/1852040394/draft/2023-09-25_fq2iiw5zgbls.jpg?image_process=format,webp)
Assembled
![](https://makerworld.bblmw.com/makerworld/user/1852040394/draft/2023-09-25_waelp4renlog.jpg?image_process=format,webp)
Rafts: No
Supports: Doesn't Matter
Resolution: 0.2 mm
Infill: 15%
Filament material: PLA+