Caravan Awnin eyelet horizontal
Copyright Claim
Caravan Awnin eyelet horizontal
Boost
7
17
1
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
7
17
1
0
9
5
Released
Description
This is a replacement part of a original caravan Awning eyelet horizontal. This is very helpful if the original one breaks and you don't want to buy in bulk. I tested it on my Caravan and it was holding an entire festival weekend, so it is robust enough.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
Thanks to this I could easily print a replacement part for broken eyelets. You only need to think about the material before printing, due to tents get pretty hot in summer, so PLA may not always be the best choice.
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld