Don't get "caught" in the water with broken rod! 🎣

Ever broke your rod tip and lost your last eyelet? 😡 Maybe bent up one of your eyelets to where your line wouldn't feed smoothly? 😣 Well if not, trust me, it's maddening… So be prepared with a simple print! 😄

Keep fishing even after you broke your rod! 🐟😃These replacement eyelets are design with a tight open-back design so that they can snap snuggly onto your rod in any position on the rod. There's also 6 different sizes so they could replace the biggest eyelet (closest to your hand), the tiny one on the end of your rod, or anywhere in-between! This set of eyelets and some tape of your choice (to wrap around your rod before installing the eyelet to make a snug fit) stashed in your tacklebox should fix you in pinch with any broken eyelet sitch! 👍

I hope you find this print useful and please post your makes!

Printed in PETG - PLA works but not as strong or heat-resistant

Layer Height: 0.2mm

Perimeters/Walls: 3 (add more for more strength)

Infill: 20% (increase more for more strength)

Brim: Not Necessary - ignore bed adhesion warnings

Supports: Not Necessary - most printers should handle the over hangs - slow down if not

Side Note: I'd love to see someone build a DIY fishing pole with these eyelets!