Stacking shelf
Copyright Claim
Stacking shelf
Boost
34
69
8
Print Profile(1)
0.2mm layer, 2 walls, 35% infill
Designer
13.4 h
6 plates
Open in Bambu Studio
Boost
34
69
8
1
119
47
Released
Description
Stacking shelf for storing your filament, organizer boxes, stuff etc.
Configure height of shelf by your needs.
Parts:
- Bracing (connect sticks together);
- Foot;
- Panel;
- Stick 55mm;
- Stick 70mm;
- Stick 110mm
Print instructions:
Print sticks vertically close to each other with grid support, so they can hold each other and have good adhesion. Decrease print speed on higher layers to 15-30 depending on stick height.
For good strength set 100% infill for connection parts of the sticks.
Comment & Rating (8)
All
Boosted
I like them! I was looking for a shelf design that is compact to pack, not too much material when printing and will hold my wares when I'm at markets and venues. I think these will be perfect. I did print them at 100% infill so that may have made them stronger, and I don't think they will hold a lot of weight. But for me this will work nicely.
The designer has replied
0
Reply
Glad it come handy to you, thank you for your feedback!
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
Like someone else said, a bit flimsy
Could use additional bars for support
The designer has replied
0
Reply
Looks nice, love the colors! I'll try to figure out how to improve flimsiness
(Edited)1
Reply
Boosted
Thanks, just what I needed.
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
Prints well but is kind of flimsy.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld