USB Hole cover for P1P/P1S
Copyright Claim
USB Hole cover for P1P/P1S
Boost
11
22
20
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
7 min
1 plate
Open in Bambu Studio
Boost
11
22
20
2
90
46
Released
Description
Quite stiff in place cover for USB hole on top of P1P and P1S printer.
I used PLA for this, but other filaments might work as well.
Comment & Rating (20)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
"-Like a glove."
Printed with PLA
Thank you!
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
fit perfect. Petg cf
0
Reply
Boosted
Fits perfect!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nize
0
Reply
Boosted
Fit 10/10 + Satisfaction Click
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
perfect
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Der wohl kleinste Druck bisher
0
Reply
Piece printed quick, and clean! Fit into the slot without any effort.
Only issue I see is - how do I remove it? I've tried reaching inside to try and push it out from the bottom since it is flush at the top, but no luck. I have yet to try and pry it with something thin, but I don't mind leaving it in there to stop the dust entering the hole.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Klein aber fein, vielen Dank
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld