Low Profile, High Airflow, LED riser for X1C/P1S by Henryk

Henryk

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 25% infill

Designer

5.5 h

2 plates

4.8(21)

0.2mm layer, 3 walls, 20% infill

5.3 h

2 plates

Boost

172

139

Released

Description

This is a low profile riser for the top cover glass of the X1C and P1S/P1P 3D Printers.

It is designed for optimal airflow while being very slim and using very little material. You can print it without supports and assemble it without glue.

The riser has an angled lid on the inside for attaching an LED Strip. You can use most USB LED Strips.

I've used the 5600K White Light LED strip sold by bambu lab and plugged it to the internal USB connector of the printer.

The riser has little clips you can use for cable management.

You will need some interface material between the riser and both the printer and the glass top to prevent vibrations and rattling. Small strips of double sided tape work great for me. Thin EVA Foam should work as well.

Comment & Rating (29)

@madmorgans

Boosted

Print Profile

0.2mm layer, 3 walls, 25% infill

excellent used my little hobby vice to press joints together thanks it's just what I needed 😀

@3dbutze

Hi Madmorgans, what i this thing in front of the AMS ?

(Edited)

@madmorgans

Boosted

hi it's a tapo c110 wi-fi camera the p1s camera is annoying so this lets me check prints in real time I found this was the best way to mount it and got the mount print off printables

(Edited)

@3DprintK81

Print Profile

0.2mm layer, 3 walls, 25% infill

great job 💪🏻👍🏻

@TNTMoore

Print Profile

0.2mm layer, 3 walls, 25% infill

oh yeah! Just what I was looking! not bad at all! i had to reprint but only due to issues with my filament- all good on your end!

@WillowTattoo

Print Profile

0.2mm layer, 3 walls, 25% infill

love this design, simple, printed super easy and just works perfectly! I added a cob light strip I got on Temu, pretty sure it’s only 1m - it goes 75% of the way around which is all you need added a picture with the door closed, open and on the app

@user_1231703484

Boosted

thank you for this print, I was so tired of having my lid open since I print mainly PLA. I wound up printing these for all of my printers! I love how it only takes 2 plates to make a kit also. thanks again! Geetech Silver for the X1C and Elegoo Basic for the P1S’s

@lars_

Boosted

This is great - I printed one for my P1P with ARC enclosure and P1S with AMS. I used LED Strip Lights Set of 2 Pack 1M/3.28FT COB Light Strips USB 5V, 6500K Bright White from Amazon to light them. As someone else mentioned, it doesn't go all the way around, but works fine. I didn't actually use the integrated wire clips, I just coiled the wire in the area next to the USB socket and that seems to work fine. I haven't noticed any rattle, so haven't added any double-sided tape.