Low Profile, High Airflow, LED riser for X1C/P1S

Low Profile, High Airflow, LED riser for X1C/P1S

Boost
40
72
24

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 25% infill
0.2mm layer, 3 walls, 25% infill
Designer
5.5 h
2 plates
4.8(19)

0.2mm layer, 3 walls, 20% infill
0.2mm layer, 3 walls, 20% infill
5.3 h
2 plates

Boost
40
72
24
6
164
136
Released

Description

This is a low profile riser for the top cover glass of the X1C and P1S/P1P 3D Printers.

It is designed for optimal airflow while being very slim and using very little material. You can print it without supports and assemble it without glue.

The riser has an angled lid on the inside for attaching an LED Strip. You can use most USB LED Strips.

I've used the 5600K White Light LED strip sold by bambu lab and plugged it to the internal USB connector of the printer.

The riser has little clips you can use for cable management.

You will need some interface material between the riser and both the printer and the glass top to prevent vibrations and rattling. Small strips of double sided tape work great for me. Thin EVA Foam should work as well. 

 

 

Comment & Rating (24)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 25% infill
excellent used my little hobby vice to press joints together thanks it's just what I needed 😀
1
Reply
Hi Madmorgans, what i this thing in front of the AMS ?
(Edited)
1
Reply
hi it's a tapo c110 wi-fi camera the p1s camera is annoying so this lets me check prints in real time I found this was the best way to mount it and got the mount print off printables
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
great job 💪🏻👍🏻
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
oh yeah! Just what I was looking! not bad at all! i had to reprint but only due to issues with my filament- all good on your end!
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
love this design, simple, printed super easy and just works perfectly! I added a cob light strip I got on Temu, pretty sure it’s only 1m - it goes 75% of the way around which is all you need added a picture with the door closed, open and on the app
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
non male ma ho preferito solo gli angolari
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
perfect.
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
thanks. perfect fit
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
Works great!
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
excellent print!!
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
perfect print
1
Reply