I had an AI generate a picture of Spiderman and I think took that photo and put it into Hueforge so that it could be printed. I recommend using whatever technique you like to make it thicker but I split the model at the first layer then made that layer 2 mm taller on the Z. This does change the layer on filament changes but its easy to figure out. Printing without doing this is fine as well it just wont be as thick.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA PolyTerra Lava Red Transmission Distance: 1
PLA PolyTerra Sapphire Blue Transmission Distance: 0.3
PLA PolyLite White Transmission Distance: 5

Swap Instructions:
Charcoal Black until layer #5 at 0.48mm
Lava Red until layer #10 at 0.88mm
Sapphire Blue until layer #19 at 1.6mm
White for the rest.