Halloween Pikachu Pumpkin
Copyright Claim
Halloween Pikachu Pumpkin
Boost
51
78
21
Print Profile(3)
0.2mm layer, 3 walls, 100% infill
Designer
1.5 h
1 plate
0.2mm layer, 2 walls, 100% infill
Designer
1.6 h
1 plate
DOOR DECORATION 0.2mm layer, 3 walls, 100% infill
Designer
7 h
1 plate
Boost
51
78
21
1
110
66
Released
Description
Based off of the Trick-or-Trade symbol on the card set. I put some old 3d printer magnetic sheet on the back to make them into magnets.
Second profile has an added hole for making a keychain.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 3 walls, 100% infill
There were a few little holes where a single color got too thin to print, but other than that it looks great! Glued some magnet paper on the back and it's happily living on my fridge.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
Very nice ;)
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
Print came out great!!!
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
Printed a plate of 6 of these and they all turned out great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 100% infill
0
Reply
Print Profile
DOOR DECORATION 0.2mm layer, 3 walls, 100% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld