this is a hueforge wall art of some Palm trees with the sunset in the back ground.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA Sunlu Matte White Transmission Distance: 5

Swap Instructions:

Start with Black

At layer #11 (0.56mm) swap to Red

At layer #22 (1mm) swap to Yellow

At layer #32 (1.4mm) swap to White for the rest.

please follow the settings in the bambu wiki seen below for best Results.

(1) Adjust the min layer height to 0.04 mm.

(2) Confirm specific process parameters