Yoshi
Remixed by
Copyright Claim
Yoshi
Remixed by
Boost
6
7
7
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
6
7
7
0
30
15
Released
Description
Found this nice Yoshi modell and wanted to share it with you! It turned out very good with only few supports on critical areas.
I printed it in circular mode and with 0.16 layer
added a 3mf with supports :-)
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
won't stand up front heavy but printed great
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:this model needs additional support. Otherwise it does not print. I wasted quita a bit of filament to find this out.
The designer has replied
0
Reply
I am very sorry to read that. There should be a 3.mf with supports to choose as well. Did this one cause you trouble?
0
Reply
I did not know there is a 3mf with support. Will try it and let you know.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:stützstruckturen fehlen komplett unter den armen
The designer has replied
0
Reply
hello, the print worked fine without support on the P1S. Therefore I did not see the need in adding support to the profile. But I will add some, no problem :)
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld