Stripped Hot End/Nozzle Box
Remixed by
Copyright Claim
Stripped Hot End/Nozzle Box
Remixed by
Boost
7
19
8
Print Profile(1)
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
Designer
1.7 h
1 plate
Boost
7
19
8
0
63
48
Released
Description
Storage box for 4 stripped/non complete hotends.
Easy Print. Lid is slight friction fit and stays on well. Hot ends sit nice and nug in their spots.
Original model is a single box, I remixed it to create this one that holds 4 of them.
Comment & Rating (8)
All
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
Gorgeous print. Perfect fit.
The designer has replied
0
Reply
Appreciate the review! glad you like it!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
I didn’t know I needed this until I needed it , hot ends fit perfect and being able to see the nozzle sizes great forward thinking !
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
The hot and fit great the lid is just very tight and you need to pry it off every time other than that it’s a perfect design. Thank you.
The designer has replied
0
Reply
Thanks for the feedback! The lid is a very close tolerance fit, I agree. It was the only way to make sure it didn't just fall off on its own when handling it. Some time in the future I may add a hinge and clips to make it looser but also still secure.
Alternatively, you can experiment with scaling the lid up slightly to find the fit you are looking for.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill. Simple and easy generic profile
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld