Flush fitting Z axis cover for Bambu Lab X1 / X1 Carbon
Remixed by
Copyright Claim
Flush fitting Z axis cover for Bambu Lab X1 / X1 Carbon
Remixed by
Boost
41
95
44
Print Profile(1)
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
11 min
1 plate
Open in Bambu Studio
Boost
41
95
44
0
312
125
Released
Description
Unlike previous covers, these ones are designed to be low profile and sit flush on the bearings, printed with TPU and 0,2mm nozzle. This is not recommended by Bambu Lab so big boy pants on and create a new filament profile, the profile in the image is not super tuned and TPU is very stringy, so for best results print one at the time.
Don't forget to turn on “Detect thin walls”
Since they TPU its still possible to pull them out with just your finger nail on the edge, if printing with something harder you might wanna use a smaller object. So TPU recommended.
Comment & Rating (44)
All
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
perfekt
The designer has replied
0
Reply
Thanks for reviewing, I appreciate the feedback!
0
Reply
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
Lies sich sehr schnell drucken und passt perfekt
The designer has replied
0
Reply
Danke!
0
Reply
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
Thanks! [petg]
The designer has replied
0
Reply
Thanks to you!
0
Reply
Nice, simple, quick print that improves the look of the printer and adds longevity to the bearings. I printed in eSun ABS Max
(Edited)
1
Reply
The print profile is no longer public
The designer has replied
1
Reply
Thanks for reviewing, I appreciate the feedback.
(Edited)1
Reply
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
(Edited)
The designer has replied
0
Reply
Thank you!
(Edited)1
Reply
The print profile is no longer public
The designer has replied
1
Reply
Thanks for reviewing, I appreciate the feedback. What was wrong with your print?
0
Reply
no problems the app won't let me rate a 5 star due to the first print failing but it was a problem on my end for some reason it doesn't register the second print I did wich was a success
(Edited)
0
Reply
Replying to @gagebounds
Thank you for your response, not problem for the rating, happy printing
0
Reply
The print profile is no longer public
The designer has replied
1
Reply
Thanks for reviewing, I appreciate the feedback.
0
Reply
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
The designer has replied
0
Reply
Thanks for reviewing, I appreciate the feedback!
0
Reply
Print Profile
X4 10 minutes print, 0.16mm layer, 2 walls, 10% infill
The designer has replied
0
Reply
Thanks for reviewing, I appreciate the feedback!
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld