Covertec Wheel Lightsaber Wall Mount (Sabertrio Aeryn) by christianselig

christianselig

Tools>Organizers

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.12mm layer, 2 walls, 15% infill

Designer

35 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

I couldn't find a model for a lightsaber wall mount that wasn't bulky and super visible, and I noticed my lightsaber (Sabertrio Aeryn) had a Covertec wheel, so I figured I'd leverage that to make a little wall mount. Just attaches with a standard small drywall anchor and screw.

It does need an attachment at the top however to keep the top part from tipping over. I use a clear “snap in” holder from Amazon but there's surely many 3D printable options.

Comment & Rating (5)

@SuperTech

Print Profile

0.12mm layer, 2 walls, 15% infill

they print out no problem but the savers are not the same so some are way to tight and others are way to loose. will not work for me

The designer has replied

@christianselig

Interesting, I wish I had as many sabers as you! Which ones don't fit? This was for my Aeryn

@SuperTech

Replying to @christianselig :

I have about 30 all from Disney. the tolerances are just too tight. the Disney belt clip fits on every single one no problem. I bought 15 on my last trip

@christianselig

Replying to @SuperTech :

Wow, I wish we were friends! That's awesome

@SuperTech

can you loosen up the tolerance on these I have 30 sabers from Disney, some they are very loose and that’s perfect some are tight some are way to tight and some don’t fit. I believe if it was slightly looser It would work on all of them

No more