Anker 525 wall mount case
Copyright Claim
Anker 525 wall mount case
Boost
0
5
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
0
5
3
0
11
7
Released
Description
Case to mount Anker 525. You can mount it vertically or horizontally.
Use M3 screws, anything longer than 8mm should work.
Two holes on the bottom of the case, allow easy access for a screwdriver.
Small tab on the left side was made to make sure that ANKER would not slide out of the case.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
fits nice and looks good. one suggestion for improvement would be to add a retention arm to the front
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld